Model X: 2018 won’t drive after a normal overnight charge
In plain words
This 2018 Model X Performance would not drive the morning after a normal overnight charge: the battery had opened its contactors. Testing ruled out the 12V battery, insulation, and a dead cell group. A specialist shop repaired the wiring that reads cell voltages inside the high-voltage battery.
FOR A QUALIFIED TECHNICIAN (shop notes, as recorded)
Symptoms
Vehicle powers on but will not drive. GTW (gateway module) LOCKED / SPEED LIMITED. HV (high voltage) battery contactors open, BMS State Fault / STANDBY. Overnight L2 charge completed normally, then BMS latched open VSH after the charge ended. HVIL green. 12V healthy. Isolation good. Bricks tracked within ~10 mV through drive and charge.
Alerts shown
BMS_w177_OpenVshDetectedBMS_u008_limpModeBMS_f071_SW_SM_TransCon_Not_MetGTW_w405_12VNotSupportedTAS_a201_low12VBatteryPM_w041_dasMIATHC_w0176ESP_d137
Safety: This repair involves the high-voltage battery and drive system. Leave diagnosis and parts replacement to a qualified technician with high-voltage training and the right equipment.
Tests run
- Service Mode: BMS_u008 + BMS_w177 active, contactors Open/Opening, HVIL green, BMS State Fault
- Toolbox Garage: BMS STANDBY, pack ~385 V, min/max brick rounded 4 V / 4 V, isolation 8343 kOhm, 12V 13.1 V
- CAN (Controller Area Network, the car's data network) Explorer 7-day: brick min/max track together ~3.55–4.08 V (no 0 V brick); -600 A drive evening before fault; L2 charge 00:00–05:50 at +8–9 A, bricks 3.80→4.00 V, delta ≤10 mV; w177 set ~06:43 after charge ended
- CAN Explorer brickNum: during charge min held ~32 and max ~50; later min ~78–80; after 06:00 max ID chatters (equal bricks). Contactors CLOSED through charge, then hunt OPEN/PRECHARGE
- Toolbox Actions: only VSH routine is PROC_BMS_X_CLEAR-LATCH-BITS (Clear BMS Open VSH Latch). Not run — Tesla text says only after reman pack or engineering
- Isolation and 12V ruled out as root cause. Dead brick ruled out by min/max tracking through charge and high-current drive.
Confirmed fix
Sent the vehicle to a specialist shop that repaired the Voltage Sense Harness (VSH / wiring harness) inside the high-voltage battery pack.
Related cases
Want this checked? Book S 3 X Y Auto Service, Mission Viejo
Book S 3 X Y Auto Service Call (949) 741-7399